_ MICCROWAX is a single-material wax for selective stop-off that is especially suited for masking on complicated parts and sharp edges.

_ MICCROWAX will not crack, and may be readily melted for use by any common heating medium.

_ MICCROWAX shows a remarkable degree of adhesion, even when used on flat surfaces. It requires no prime coat before application which means only one dip tank is necessary for the complete operation.

MiCCROWAX hardens immediately after the part is dipped, thereby minimizing preparation time and speeding production of parts before plating.

_ MICCROWAX can be reused without loss of its efficiency.

_ MICCROWAX may be used in most plating cycles as long as cycle temperatures do not exceed the melting point of the wax.

_ MICCROWAX may be used in the following types of plating: Hard Chrome Indium Copper Acid Lead Copper Pyro Silver

APPLICATION AND REMOVAL PROCEDURES

MICCROWAX C-562 should be held at temperatures between 1 75_F. and 1 85_F. to attain a maximum thickness of coating for use in selective hard chromium plating. The parts to be stopped-off should be cleaned of all dirt, grease, etc. Immerse in MICCROWAX for a few moments to raise the temperature of the part and withdraw. Two or three successive, fast dips will provide a heavy coating that will withstand any hard chromium cycle. The portion to be plated can be bared with a knife and the surface cleaned with naphtha before plating.

MICCROWAX C-562 can be removed easily by peeling or placing part in boiling water to melt the coating.

MICCROWAX C-562 comes in 10 lb. cakes, 5 cakes per carton. 7.8# gal. when melted. 51 # per cu. ft. when melted.

PRECAUTIONARY INFORMATION

STORAGE: This coating material should be stored and used in accordance with normal standards of good practice for handling industrial paints.

USE: Maintain adequate ventilation in working area. Wear approved respirators and protective clothing when working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of material with the skin may be irritating; wash exposed surface thoroughly with soap and water. In case of eye contact, flush out the eyes with water for 15 minutes and consult a physician.

Developed and manufactured by experienced platers